Services
Services
The measurement and calibration disciplines available through Minneapolis CMM Calibration and Repair.

What Is Offered
CMM calibration and repair is the core offer. Programming support and gage calibration round out what a quality department already keeps on one recall schedule.
Services Offered
Each discipline below has its own page setting out method, scope and what a request should contain.
- 01
CMM Calibration and Repair
Performance verification, geometric adjustment and repair for bridge, gantry and portable arm CMMs.
Show → - 02
CMM Programming
Offline and online part programs built to measure what the drawing requires, not just to run.
Show → - 03
Gage Calibration
Calipers, micrometers, gage blocks, plug and ring gages, and surface plates on one recall schedule.
Show →
How a Job Is Completed
Work is performed under ISO/IEC 17025:2017. Methods, ranges and measurement points are agreed against the request before anything is measured. The certificate or report issued afterwards states the method used, the measurement conditions and the uncertainty that applies.
Coverage across Minneapolis, MN and the wider Minnesota and the Greater Midwest area is listed on the service areas page. The standards, traceability and management arrangements behind the work are set out on the quality system page.
Have a specific item to quote?
Send the item, measurement points, tolerances and required turnaround, and a written quotation is prepared and returned.