Skip to content

Supporting service

CMM Programming


Request a quotation for program development.

Request a quotation

A written quotation follows by email.

A program that runs is not a program that measures

Programming work covers GD&T interpretation from print or model, datum structure and alignment strategy, and fixture and feature selection that holds up across a production run.

Platforms supported are named on the quotation: PC-DMIS, Calypso, MODUS, CAMIO, PolyWorks and Quindos are the ones most shops already run. Programs are written for the metrology software the shop operates today rather than requiring a change of platform to accept the work.

What's covered

Programs are built against the drawing or model, with probe and stylus configuration qualified before the first part runs. Alignment strategy, datum structure and tolerance interpretation are documented alongside the program file so a second programmer can pick up the same part without re-deriving the logic.

  • 01

    GD&T interpretation

    Datum structure and alignment strategy built from the print or the model, not assumed from the part.

  • 02

    Probe and stylus selection

    Configuration chosen and qualified for the feature set before programming begins.

  • 03

    Scanning vs. discrete point

    Strategy selected by feature type and tolerance, including scan time where THP is a factor.

  • 04

    Reporting output

    Output formatted for PPAP submission and first-article inspection reporting.

  • 05

    Fixture strategy

    Workholding and feature access planned before the probe path is finalized.

Development sequence

  • 01

    Review

    Print or model reviewed for datum structure and critical tolerances.

  • 02

    Build

    Program written offline or online, with probe path and stylus qualification included.

  • 03

    Prove out

    Program run against a known part and corrected before release.

  • 04

    Document

    Alignment, datum scheme and reporting setup recorded for repeat production runs.

Why Minneapolis CMM Calibration and Repair

  • 01

    Platform-specific

    Programs written in the software the shop already owns, named on the quotation.

  • 02

    PPAP-ready output

    Reports formatted for first-article and production part approval submission.

  • 03

    Alignment strategy reviewed

    Datum structure checked against the print, not inherited from a prior program.

Coverage across Minnesota and the Greater Midwest

On-site service is scheduled by route across Minneapolis and the surrounding metros listed on this site. Machines outside that radius are quoted on request.

Discuss CMM Programming Requirements

Send the print or model and the platform in use.

A written quotation follows by email.